774455葡京
Current Position:Home > Support > FAQ FAQ
No Alarm Output in RM

 

        When alarm service and RM is started up at the same time, the priority of alarm service receiving alarm is higher than that of RM. Therefore, if an alarm is sent by chassis to the computer where RM is running, the alarm output will not be displayed in the operation output of RM. If such display is necessary, please close the alarm service and then restart RM.


        The alarm service is called as AVTrace Alarm Service; it can be closed in computer management interface->stop the service as shown above.
It is further noted that the chassis only sent alarms to its resource manager and backup resource manager. In need of receiving alarms from the chassis, the ip of resource manager and backup resource manager shall be set the same as the ip address of RM.(After the setup is complete, synchronize data to the chassis)


  • 774455葡京64222葡京
  • www.pjbet.com

Guangzhou BeiJing Chengdu Shanghai

64222葡京
澳门新葡萄京
www.88919.com